Test Step 1 - Active DTC
- Ignition ON, engine not running.
NOTE:
Low battery voltage can also cause excessive current draw in very hot and very cold ambient temperatures. Make sure the battery can pass a load test before continuing.
- With a scan tool, select view DTCs.
- Look closely at the temperatures under which this DTC set.
Is the DTC active at this time?
Yes
- Go to Test Step 2 Test Step 2 - Inverter Control Output Circuit Short to Ground .
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .
- Ignition on, engine not running.
NOTE:
Low battery voltage can also cause excessive current draw, in very hot and very cold ambient temperatures. Make sure the battery can pass a load test before continuing.
- With a scan tool, select View DTCs.
- Look closely at the temperatures at which this DTC set.
Is the DTC Active at this time?
Yes
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .