Checking Wiring
-- Remove the Engine Control Module (ECM) -J623-. Refer to the Repair Information.
-- Using a multimeter, check the HO2S Oxygen Sensor Bank 1 Sensor 2 -G130- electrical harness connector T4v terminals to the Engine Control Module (ECM) -J220- electrical harness connector T94 terminals for an open circuit.
2009 - 2010 Models
| Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130- electrical harness connector terminals: | Engine Control Module (ECM) -J623- electrical connector T94 terminals: |
|---|---|
| 3 | 71 |
| 4 | 62 |
2011 >
| Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130- electrical harness connector terminals: | Engine Control Module (ECM) -J623- electrical connector T94 terminals: |
|---|---|
| 3 | 72 |
| 4 | 84 |
Specified value: 1.5 Ω Max.
If the specified value was Not obtained:
-- Check the wiring for an open, high resistance, short circuit to each other, Battery (+) or Ground.
-- Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-- If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and the voltage supply was Not OK:
-- Replace the Engine Control Module (ECM) -J623-. Refer to the Repair Information.
-- Assembly is performed in the reverse of the removal.