Specifications Index
SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT R134A | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 200 Nm +180° | ||
| Rear | 180 Nm + 90° turn | ||
| Battery | GENERAL INFORMATION | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM, BLEEDING Hydraulic Components | ||
| Disc Brakes | N/A | ||
| Torque | N/A | ||
| Charging | |||
| Generator | N/A | ||
| Torque | |||
| Drive Belts | |||
| Adjustment | |||
| 2.0L | RIBBED BELT | ||
| 2.5L | RIBBED BELT | ||
| Belt Routing | |||
| 2.0L | See fig. 21 under RIBBED BELT | ||
| 2.5L | See fig. 6 under ACCESSORY DRIVE | ||
| Engine Cooling | |||
| General Service Specifications | Refer to the approrpiate FLUID CAPACITY TABLES information. | ||
| Radiator Cap Pressure | |||
| 2.0L | 1.4 to 1.6 bar | ||
| 2.5L | 1.4 to 1.6 bar | ||
| Thermostat R & I | |||
| 2.0L | COOLANT THERMOSTAT | ||
| 2.5L | COOLANT THERMOSTAT | ||
| Water Pump R & I | |||
| 2.0L | COOLANT PUMP | ||
| 2.5L | COOLANT PUMP | ||
| Engine Mechanical | |||
| 2.0L | |||
| Compression | COMPRESSION, CHECKING | ||
| Oil Pressure | At 2000 RPM and an oil temperature of 80 °C (176 °F), the oil pressure must be at least 2.0 bar. The oil pressure must not exceed 7.0 bar at higher engine speeds. |
||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| 2.5L | |||
| Compression | COMPRESSION, CHECKING | ||
| Oil Pressure | The LED must illuminate at 1.2 to 1.6 bar At higher engine speeds the oil pressure must not exceed 7.0 bar At 2, 000 RPM and an oil temperature of 80 °C (176 °F), the oil pressure must be 2.7 to 4.5 bar. |
||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate Torque | 60 Nm + 90° | ||
| Fuel System | |||
| Pressure Specification | |||
| 2.0L | approximately 10 bar | ||
| 2.5L | 3.8 to 4.2 bar | ||
| Fuel Pressure Test Procedure | |||
| 2.0L | Fuel Pressure Regulator Valve -N276-, CHECKING | ||
| 2.5L | FUEL PRESSURE REGULATOR AND RESIDUAL PRESSURE, CHECKING | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil-On-Plug | ||
| Ignition Wires (Routing) | Coil-On-Plug | ||
| Spark Plug | |||
| 2.0L | Glow Plug | ||
| 2.5L | TECHNICAL DATA | ||
| Starting | |||
| Starter | N/A | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFIED VALUES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 120 Nm | ||