Description And Operation: Tachometer

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.

The tachometer is serviced as a unit with the instrument cluster.

The tachometer gives an indication to the vehicle operator of the engine speed. This gauge is controlled by the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from the PCM over the controller area network data bus.

The tachometer is driven by an electronic stepper motor unit that receives battery current on the instrument cluster electronic circuit board through the fused ignition switch output (run-start) circuit whenever the ignition switch is in the ON or START positions. The cluster is programmed to move the gauge needle back to the low end of the scale after the ignition switch is turned to the OFF position. The instrument cluster circuitry controls the gauge needle position and provides the following features:

>>Engine Speed Message<< - Each time the cluster receives an electronic engine speed message from the PCM it will calculate the correct engine speed reading and position the gauge needle at that relative speed position on the gauge scale. The cluster will receive a new message and reposition the gauge pointer accordingly about every 88 milliseconds. The gauge needle will continually be repositioned at the relative engine speed position on the gauge scale until the engine stops running, or until the ignition switch is turned to the OFF position, whichever occurs first.
>>Communication Error<< - If the cluster fails to receive a speed message, it will hold the gauge needle at the last indication for about three seconds, or until the ignition switch is turned to the OFF position, whichever occurs first. After three seconds, the gauge needle will return to the left end of the gauge scale.
>>Actuator Test<< - Each time the cluster is put through the actuator test, the tachometer needle will be swept to several calibration points on the gauge scale in a prescribed sequence in order to confirm the functionality of the gauge and the cluster control circuitry.

The PCM continually monitors the crankshaft position sensor to determine the engine speed. The PCM then sends the proper engine speed messages to the electromechanical instrument cluster, also known as the cabin compartment node.

For proper diagnosis of the crankshaft position sensor, the PCM, the EMIC, the CAN data bus or the electronic communication related to tachometer operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.