Common Specs & Procedures
TIGUAN - COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REMOVAL AND INSTALLATION | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | FASTENER TIGHTENING SPECIFICATIONS | ||
| Rear | FASTENER TIGHTENING SPECIFICATIONS | ||
| Battery | BATTERY, STARTER, GENERATOR, CRUISE CONTROL - GENERAL INFORMATION | ||
| Brakes | |||
| Bleeding Sequence | GENERAL INFORMATION | ||
| Disc Brakes | DESCRIPTION AND OPERATION | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS
for Mechanical Components FASTENER TIGHTENING SPECIFICATIONS for Hydraulic Components |
||
| Charging | |||
| Generator | NA | ||
| Torque | NA | ||
| Drive Belts | |||
| Adjustment | N/A | ||
| Belt Routing | N/A | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | 1.4-1.6 Bar | ||
| Thermostat R & I | COOLANT THERMOSTAT | ||
| Water Pump R & I | COOLANT PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE, CHECKING | ||
| Oil Pressure | At 2000 RPM and an oil temperature of 80°C (176°F), the oil pressure must be between 2.0 and 4.5 bar. | ||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | See FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate Torque | 60 Nm + 90° | ||
| Fuel System | |||
| Pressure Specification | Specified value: 4.0 to 7.0 bar | ||
| Fuel Pressure Test Procedure | FUEL PUMP, CHECKING | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil-On-Plug | ||
| Ignition Wires (Routing) | Coil-On-Plug | ||
| Spark Plug | TECHNICAL DATA AND SPARK PLUGS | ||
| Starting | |||
| Starter | |||
| Torque | |||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFIED VALUES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS
for front axle FASTENER TIGHTENING SPECIFICATIONS for rear axle |
||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 140 Nm for FWD 120 Nm for AWD |
||