Electrical Sensor Dynamics: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When installed, arrow on dynamics sensor housing must point towards front of vehicle.

-- Position the dynamics sensor (2) on the mounting bracket (4) with the arrow pointing to the front of the vehicle and the connector facing the passenger side of the vehicle.

-- Install the two mounting screws (1). Tighten the screws to 9 Nm (80 in. lbs.).

-- Connect the wiring harness connector (3) to the dynamics sensor (1).

Fig 1: Identifying Dynamics Sensor Bracket, Connector And Screws

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the right intermediate floor distribution duct (2).

Fig 2: Identifying Right Intermediate Floor Distribution Duct

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the instrument panel center support brackets (3) and mounting screws (2). There is one bracket on each side of the tunnel structure.

Fig 3: Identifying Instrument Panel Center Support Brackets And Fasteners

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Reinstall the carpet onto the front floor pan and under the instrument panel. Refer to Removal and Installation .

-- Install the instrument panel center stack console. Refer to Removal and Installation .

Fig 4: Identifying Center Stack Console And Fasteners

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the battery negative cable to the battery post.

-- Perform the Diagnostic Verification Test and clear any faults. Refer to BRAKE SYSTEM DTC BASED DIAGNOSTICS (B1783-01 TO U140E-00)BRAKE SYSTEM DTC BASED DIAGNOSTICS (C0021 - U1503) .