Multifunction Transmission Range Switch -F125- : Removing

-- Move the selector lever into the "N" position.

-- Turn off the ignition.

-- If necessary remove the air filter housing:

Refer to [For engine(s) CBTA,CBUA] Removal and Installation .

-- To remove the selector lever cable from the transmission, disconnect the selector lever cable by releasing the clip in the -direction of the arrows 1- and then remove the selector lever cable from the cable mounting bracket in the -direction of arrow 2- .

Fig 1: Identifying Cable Disengaged And Removed From Mounting Bracket

NOTE:

Do not use pliers because the tabs on the cable bracket could break off.

Do not bend the selector lever cable.

-- Pry the selector lever cable -1- off the selector shaft lever -3- using a wrench -2- .

Fig 2: Identifying Selector Lever Cable, Lever/Selector Shaft And 10mm Open-End Wrench

-- Disconnect the connector from the Multifunction Transmission Range Switch -F125- .

-- Remove the nut -1- .

Fig 3: Identifying Selector Shaft Lever Components

-- Remove the spring washer -2- and the lever -3- from the selector shaft -4- .

-- Bend back the hooks on the lock washer -2- using a screwdriver.

Fig 4: Identifying Selector Shaft Components

-- Replace the lock washer is a hook breaks off.

-- Remove the nut -1- .

-- Remove the bolts -5- .

-- Remove the Multifunction Transmission Range Switch -F125- -4- and the washers -2 and 3- from the selector shaft -6- .