LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2011 >> Jetta Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 81 (2.0L - Diesel Fuel Injection - Engine Code: CJAA (Sedan)) >> 23 Diesel Fuel Injection >> Removal And Installation >> Engine Control Module -J623-
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Control Module -J623-

WARNING: This page is about a different variant/trim than selected.
NOTE:

If the Engine Control Module -J623- is to be replaced, connect the vehicle diagnostic tester and perform "Guided Functions, Replacing Engine Control Module".

Conditions 

Removing 

-- Remove the E-box cover -arrows- inside the engine compartment.

Fig 1: Identifying Engine Control Module (E-Box) Cover
GWWM24-10006Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

With Anti-Theft Protection

Fig 2: Identifying Connectors, Bolts, Bracket And Locking Mechanism
GWWM24-10007Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the shear bolts -2-.

-- Remove the locking mechanism bracket -5-.

-- Disconnect the connectors -1 and 3- from the Engine Control Module -J623-.

-- Remove the shear bolts -6- and the lock mechanism bracket -4-.

Without Anti-Theft Protection 

Fig 3: Identifying ECM, Screwdriver And Side Guides
GWWM24-10008Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connectors -1 and 3- from the Engine Control Module -J623-.

Continuation for All 

Fig 4: Identifying ECM, Screwdriver And Side Guides
GWWM24-10008Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the tabs on the side guides -3- carefully toward the outside -direction of arrow- with a screwdriver -2-.

-- Remove the Engine Control Module -J623- -1- from the guides -3-.

Installing 

-- Install the Engine Control Module -J623- -1- into the guides -3- until it locks.

With Anti-Theft Protection 

Fig 5: Identifying Connectors, Bolts, Bracket And Locking Mechanism
GWWM24-10007Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the locking mechanism bracket -4- to the Engine Control Module -J623- with the shear bolts -6-.

-- Install the shear bolts until the bolt heads break off.

-- Connect the connectors -1 and 3- to the Engine Control Module -J623-.

-- Install the locking mechanism bracket -5- with the shear bolts -2-.

-- Install the shear bolts until the bolt heads break off.

Without Anti-Theft Protection 

-- Connect the connectors -1 and 3- to the Engine Control Module -J623-.

Continuation for All 

Fig 6: Identifying Engine Control Module (E-Box) Cover
GWWM24-10006Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the E-box cover -arrows-.