Windshield Washer Fluid Level Sensor -G33-
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Turn off the ignition and all electrical consumers.
- Remove the key.
Removal
-- Remove the front bumper cover. Refer to Removal and Installation .
-- Disconnect the connector -1- from the windshield washer fluid level sensor -2-.
-- Pull the windshield washer fluid level sensor -2- out of the rubber seal.
-- Catch any draining washer fluid in a suitable container.
Installation
Installation is performed in the reverse order of removal. Note the following:
-- Bleed the headlamp washer system. Refer to HEADLAMP WASHER SYSTEM, BLEEDING .