ATF Cooler, Rectangular Version: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into >>P<<.

-- Remove the engine cover with the air filter. Refer to REMOVAL AND INSTALLATION , REMOVAL AND INSTALLATION or REMOVAL AND INSTALLATION .

Fig 1: Identifying Engine Cover And Air Filter Assembly

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the battery and the battery tray. Refer to REMOVAL AND INSTALLATION .

Fig 2: Identifying Battery Tray

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the selector lever cable on the retaining clip -arrow-.

Fig 3: Identifying Selector Lever Cable

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Mark the ATF cooler coolant hoses to prevent confusing them when installing them later.

The coolant system is under pressure when the engine is warm.

Cover the cap on the reservoir with a cloth and open it carefully before removing the coolant hoses.

-- Clamp the coolant hoses with the Hose Clamps - Up To 25mm 3094 -arrow- and remove them from the ATF cooler.

Fig 4: Identifying Hose Clamps

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Seal the coolant hoses and connections with suitable plugs taken from the Engine Bung Set VAS 6122.

-- Remove the bolts -arrows- and take out the ATF cooler.

Fig 5: Locating ATF Cooler Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.