Instrument Cluster
Special tools and workshop equipment required
- Release Lever T10039
- Wedge T10039/1
Removal
- It is not necessary to remove the steering wheel. To improve clarity, the steering wheel is not shown in the following illustrations.
- If the instrument panel insert is to be replaced, refer to INSTRUMENT CLUSTER, REMOVING AND INSTALLING .
-- Using the electrical or mechanical adjustment mechanism, fully extend and lower the steering wheel.
-- Turn off the ignition and all electric consumers and remove the key.
-- Pry trim strips -1- and -2- out of locking mechanisms using T10039/1.
-- Remove bolts -1- from upper cover piece of steering column -2- and remove it.
-- Remove instrument cluster visor. Refer to Removal and Installation .
-- Remove bolts -1- from bracket of instrument cluster visor -2-.
-- Remove screws -1-.
-- Remove bracket for instrument cluster visor -1- upward in -direction of arrow-.
-- Remove instrument cluster and disconnect harness connectors -1- on rear side of instrument cluster.
Installation
Install in reverse order of removal. Note the following:
-- Place the instrument panel insert into the opening and connect the connectors.
-- Install bracket for instrument cluster visor.
-- After installing, test the functions of the instrument cluster.