ADBLUE® Delivery Module Overview
WARNING: This page is about a different variant/trim than selected.
- Wiring Harness
- Delivery Line
- For the reducing agent.
- With the reducing agent line heater -Z104-.
- Assembly overview, refer to REDUCING AGENT (ADBLUE®) DELIVERY LINE OVERVIEW .
- Bolt
- 5 Nm
- Reducing Agent Pump -V437-
- With the reducing agent pump heater -Z103-.
- With the reducing agent metering system pressure sensor -G686-.
- With the reducing agent reversing valve -N473-.
- Seal
- Always replace
- Gasket
- Always replace.
- Locking Ring
- 80 Nm
- Remove and install using special wrench T50014.
- Delivery Module
- With the reducing agent tank heater -Z102-.
- With the reducing agent reservoir sensor -G697-.
- With the reducing agent temperature sensor -G685-.
- Removing and installing, refer to REDUCING AGENT (ADBLUE®) DELIVERY MODULE .
- Seal
- Replace if damaged.
- Filter
- Seal
- Replace if damaged
- Cap
- For filling
- Accessible from the luggage compartment.