Test Step 6 - Check The (C807) Common Door Driver 2 Circuit For An Open

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking (C807) Common Door Driver 2 Circuit For An Open

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Measure the resistance of the (C807) Common Door Driver 2 circuit between the A/C Heater Control C1 harness connector and the Recirculation Door Actuator harness connector.

Is the resistance above 1.0 Ohm?

Yes

Repair the (C807) Common Door Driver 2 circuit for an open or high resistance.
Perform the HVAC Verification Test. Refer to HVAC .

NOTE:

Probable location is the wiring harness splice or the wiring between the splice and the door actuator.

Replace the Recirculation Door Actuator. Refer to REMOVAL AND INSTALLATION .
Perform the HVAC Verification Test. Refer to HVAC .