Left Rear Level Control System Sensor

WARNING: This page is about a different car, the 2011 Volkswagen Eos, 2010 Volkswagen Eos, 2009 Volkswagen Eos, 2008 Volkswagen Eos, and 2007 Volkswagen Eos. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque wrench V.A.G 1331
Vehicle Diagnosis, Testing, and Information System VAS 5051

Removing

-- Disconnect the connector.

Fig 1: Identifying Left Rear Level Control System Sensor Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Remove the bolts.

-- Remove left rear level control system sensor -G76-.

Installing

Installation is performed in the reverse order of removal. Observe the following when doing so:

The level control system sensor lever must point toward vehicle exterior.

-- Perform a basic setting on the adaptive chassis DCC. Refer to ADAPTIVE CHASSIS DCC, BASIC SETTING .

-- Perform a basic setting on the headlamps via the Guided Fault Finding function with the VAS 5051.

Tightening Specifications

Component	Tightening specification
Bolt to subframe/lower transverse link	5 Nm