Multi-Pin Connector Assignment On Rear Of Front A/C Display Control Head

WARNING: This page is about a different car, the 2011 Volkswagen Eos, 2010 Volkswagen Eos, 2009 Volkswagen Eos, 2008 Volkswagen Eos, and 2007 Volkswagen Eos. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Adapter Cable V.A.G 1598/47
Template V.A.G 1598/47-2
Test box (Basic Unit) V.A.G 1598/14

Fig 1: Identifying Multi-Pin Connector Assignment On Rear Of Front A/C Display Control Head

Courtesy of VOLKSWAGEN UNITED STATES, INC.

5-Pin Harness Connector -A-, T5

1 - 3rd blower speed

2 - 2nd blower speed

3 - 1st Blower speed

4 - 4th blower speed

5 - Terminal X and depending on the vehicle equipment level Auxiliary Heater Operation Relay -J485-

16-Pin Harness Connector -B-, T16

1 - Temperature door motor -V68- - set to warm

2 - Evaporator temperature sensor -G308-

3 - Air distribution door motor position sensor -G645-

5 - Temperature regulator door motor position sensor -G92-

7 - +5 volt

8 - Ground signal

9 - Recirculation door motor -V113- set to open

10 - Recirculation door motor -V113- set to closed

11 - Temperature door motor -V68- set to cold

12 - Air distribution door motor -V428-, set to position 1

13 - Air distribution door motor -V428-, set to position 2

20-Pin Harness Connector -C-, T20a

5 - High Pressure Sensor -G65-

7 - Low speed CAN Bus

8 - High speed CAN Bus

12 - Right seat heater (optional)

13 - Left seat heater (optional)

15 - Terminal 75 seat heater (optional)

16 - A/C Compressor Regulator Valve -N280-

19 - Terminal 30A

20 - Terminal 31