Comfort System Central Control Module -J393-

WARNING: This page is about a different car, the 2011 Volkswagen Eos, 2010 Volkswagen Eos, 2009 Volkswagen Eos, 2008 Volkswagen Eos, and 2007 Volkswagen Eos. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench V.A.G 1410

NOTE:

If comfort system central control module is to be replaced, the work procedure REPLACING/CODING to read out the codes stored in the module must always be performed.

Removal

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

-- Remove the glove compartment. Refer to Removal and Installation .

-- Pull retaining tab -2- on the comfort system central control module bracket in the -direction of the arrow- and slide the comfort system central control module until recesses -1- and -3- line up.

Fig 1: Identifying Bracket Retainer And Comfort System Central Control Module J393

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The connectors can only be disengaged and disconnected when the recesses -arrows- of the connectors and bracket line up exactly.

Fig 2: Identifying Electrical Connection Recesses

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and disconnect the connectors from the comfort system central control module.

NOTE:

The number of connectors depends on the vehicle equipment.

All connectors can only be connected in one position and therefore do not need to be labeled.

-- Remove nuts -arrows- (4.5 Nm).

Fig 3: Identifying Comfort System Central Control Module J393 And Nuts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove bracket with comfort system central control module -1-.

-- Pull retaining tab -1- in -direction of arrow B- and slide comfort system central control module -2- out of bracket -3- in -direction of arrow A-.

Fig 4: Identifying Retainer, Comfort System Central Control Module J393 And Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installation

Install in reverse order of removal, noting the following:

-- Tighten the nuts to tightening specification. Refer to COMFORT SYSTEM CENTRAL CONTROL MODULE, TIGHTENING SPECIFICATIONS .

NOTE:

The connectors can only be connected and locked when the recesses -arrows- of the connectors and bracket line up exactly.

Fig 5: Identifying Electrical Connections Recesses

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.