Fastener Tightening Specifications
| Component | Fastener Size | Nm | ||||
|---|---|---|---|---|---|---|
| Bevel Box Output Flange Nut (1) | - | 675 | ||||
| Bevel Box to Transmission Bolt | - | 30 | ||||
| Drive Axle Heat Shield to Bevel Box Bolt | - | 25 | ||||
| Filling/Inspection Plug (1) | - | 15 | ||||
| Flange Shaft Countersunk Bolt (1), (2) | - | 30 | ||||
| Oil Drain Plug (1) | ||||||
| M20 | - | 60 | ||||
| M10 x 1 | - | 15 | ||||
|
||||||
Bevel Box Bracket Bolt Tightening Sequence and Specification
-- Position the bevel box bracket and install the nuts -1- and bolts -2- hand tighten.
-- Observe the installation sequence:
- Tighten the nuts -1- to 3 Nm.
- Tighten the bolts -2- to 35 Nm.
- Tighten the nuts -1- to 45 Nm.