Battery, Transmitter And Receiver Unit, Fuse And Wiring Harness Overview
- 1 -
Positive Connection
- Red wire with suitable connection
- 2 -
To terminal 15a
- Connection to terminal 15a. Refer to SYSTEM WIRING DIAGRAM.
- Ensure wire is protected by fuse
- Fuse max. 15A
- 3 -
Antenna Ground
- Ensure correct ground connection to body
- Antenna location must be treated with suitable corrosion protection
- 4 -
Transmitting/Receiving Antenna
- Installation locations, refer to TRANSMITTED OUTPUT, ANTENNA INSTALLATION LOCATIONS, GOLF FROM 2004 .
- 5 -
Shielded Antenna Wire
- Wire with coaxial connector
- 6 -
Telephone or Two-Way Radio Transmitter/Receiver Unit
- 7 -
Wiring Harness
- Voltage supply positive via read wire, 2.5 mm2 cross section
- Voltage supply negative via brown wire, 2.5 mm2 cross section
- If necessary, wire to terminal 15a via black wire 1.5 mm 2 cross section
- 8 -
Fuse Holder
- Install next to battery
- 9 -
To Starter
- 10 -
Battery
- Installation location in engine compartment
- 11 -
Negative Wire
- 12 -
Body Ground