Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
Courtesy of VOLKSWAGEN UNITED STATES, INC.
- Driving Direction
- Drive Plate to Torque Converter
- 60 Nm
- Quantity: 6, remove and install using the socket -SW15V/175-
- M12 Bolts
- M10 Bolts
- 40 Nm
- The bolts are located in the lower flange
- Arrows - Centering Sleeves
| Component |
Nm |
| Transmission mount bracket to transmission (use new bolts) |
40 + an additional 90° (1/4) turn |
| Transmission mount to transmission mount bracket (use new bolts) |
60 + an additional 90° (1/4) turn |
| Transmission fluid lines to transmission |
20 |
| Ground cable to bracket |
25 |
Courtesy of VOLKSWAGEN UNITED STATES, INC.
- Driving Direction
- Drive Plate to Torque Converter
- 60 Nm
- Quantity: 6, remove and install using the socket -SW15V/175-
- M12 Bolts
- M10 Bolts
- 40 Nm
- The bolts are located in the lower flange
- Arrows - Centering Sleeves
| Component |
Nm |
| Transmission mount bracket to transmission (use new bolts) |
40 + an additional 90° (1/4) turn |
| Transmission mount to transmission mount bracket (use new bolts) |
60 + an additional 90° (1/4) turn |
| Transmission fluid line to transmission |
20 |
| Ground cable to bracket |
25 |
| Transmission to engine and bevel box |
Refer to BEVEL BOX |
| Bevel box to transmission |
| Right drive axle heat shield to bevel box |
| Driveshaft flexible disc to bevel box |
Refer to Specifications |
| Control arm, coupling rod, pendulum support, drive axle, wheel bolts |
Refer to SPECIFICATIONS
. |