Left High Intensity Gas-Discharge Lamp (With Range Control) Control Module -J567-, Removing and Installing

Left High Intensity Gas-Discharge Lamp (With Range Control) Control Module -J567-, Removing and Installing

WARNING:
- HIGH VOLTAGE
- Always disconnect negative ( - ) battery terminal prior to servicing any parts of the HID lamp system marked with the yellow "HIGH VOLTAGE!"symbol.
- After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.

The (master) control module is located in the left front wheel housing.

Removing
- Remove left front wheel housing liner.







- Remove nuts/bolts -1- for control module.
- Disconnect electrical connection -2-.

Installing
Installation in reverse sequence of removal.
- Check headlight function.
- Code control module (function 07) using On Board Diagnostic program.
- Perform headlight basic setting (function 04) using On Board Diagnostic program.