Access/start control module J518 , removing and installing
Removing:
CAUTION:
When disconnecting and connecting battery, the procedure as described in the Repair Information must be followed.
- Disconnect battery.
- Clear the vehicle floor in the front left footwell, in front of the seat.
- Remove connector - 1 - from control module.
- Remove nuts - 2 - and remove control module.
Installing:
Install in reverse order of removal, noting the following:
- Connect battery.
NOTE:
- When disconnecting and connecting battery, the procedure as described in the Repair Information must be followed.
- If Access/Start Authorization Control Module is replaced.