With Generic Scan Tool

Catalytic Converter, Checking

Function test
- Select the measuring value "Test-ID 01: Catalytic converter" and check whether the specified values are being reached, Diagnostic mode 6: Check test results of components that are not continuously monitored. Diagnostic Mode 6: Check Test Of Parts Not Constantly Monitored
- End diagnosis and switch ignition off.

If the specified values are exceeded:
- Replace catalytic converter.
- Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data
- Generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes