General notes on ignition system
- This section deals especially with components having to do with ignition. The other components of the injection and ignition system
- The battery must only be disconnected and connected with the ignition switched off, since the Engine Control Module (ECM) can otherwise be damaged.
- Engine Control Module (ECM) is equipped with On Board Diagnostic (OBD).
- For the electric components to work properly, a voltage of at least 11.5 V is required.
- It is possible that the control module will recognize a malfunction and store a DTC during some tests. After completing all tests and repairs, DTC memory should therefore be checked and erased if necessary. "Guided functions"
- If the engine only starts briefly and then turns off again after troubleshooting, repair or checking of the components, it may be that the immobilizer is blocking the Engine Control Module (ECM). DTC memory must then be checked and if necessary, control module must be adapted "Guided functions".