Locking Cable Adjusting

LOCKING CABLE, ADJUSTING 096 TRANSMISSION






Note:
Locking cable must only be adjusted in its installation position.

- Shift selector lever into "1" position.

- Turn ignition key to right ("START" position) and release.

- Adjust clearance -a- between lever -1- and locking pin -2- by sliding locking cable casing.
- Dimension -a- 0.7 mm (0.028 in.)

- Tighten locking cable anchorage screw in this position.
Tightening torque: 6 Nm (53 in lb).

- Shift selector lever into "P" position and turn ignition key to end ("OFF") position.

- Remove ignition key.


It must only be possible to remove ignition key with selector lever in "P" position.

It must not be possible for selector lever to be shifted out of "P" position.