Central Lock, Removing/Installing

1 Central lock
2 Countersunk screw M8 x 40
3 Cable
4 Circlip
5 Sliding door/rear contact surface
6 Cable pad
Work sequence

Removing

Note

The central lock can be removed and installed with the door on the vehicle.

- remove sliding door trim panel



- remove circlip 4 from pin on remote control lock and remove cable 3
- remove screws 2 (see Fig. 58-239)
- remove central lock with cable
- remove circlip 4 and remove cable from central lock (see Fig. 58-239)
Installing

- install cable on central lock pin and secure with circlip
- push cable into door and push foam pad onto cable
- screw lock to sliding door
^ tightening torque: 23 N-m (16.9 ft.lbs.)

- install cable on remote control lock pin and secure with circlip
- stick foam pad to center of door