Clutch Release Bearing & Operating Lever Assembly: Installation
- Coat ends of push rod with multi-purpose grease and insert back into position. Grease sliding surface of bearing and guide sleeve.
- Position return spring and clutch lever inside transaxle case. Return spring center hook should fit on top of clutch lever lug. Spring end hooks must point down to hold clutch lever away from release bearing.
- Lightly coat release shaft with multi-purpose grease. Fit shaft. Work operating lever until splines on release shaft mesh with those in clutch lever.
- Install circlips. Make sure when operating lever is in normal position that return spring has tension. Fit gasket and cover.